2019 Dodge Charger Owner’s Manual — IGNITION SWITCH

Keyless Push Button Ignition

This feature allows the driver to operate the ignition with

the push of a button as long as the key fob is in the 3

passenger compartment.

The Keyless Push Button Ignition has four operating positions, three of which are labeled and will illuminate when in position. The three positions are OFF, ACC, and ON/RUN. The fourth position is START. During start, ON/RUN will illuminate.

NOTE: If the ignition switch does not change with the push of a button, the key fob may have a low or dead battery. In this situation, a back up method can be used to operate the ignition switch. Put the nose side (side opposite of the emergency key) of the key fob against the ENGINE

1 — OFF

— ACC

— ON/RUN

START/STOP Ignition Button

START/STOP button and push to operate the ignition switch.

The push button ignition can be placed in the following modes:

OFF

The engine is stopped.

Some electrical devices (e.g. central locking, alarm, etc.) are still available.

ACC

Engine is not started.

Some electrical devices are available.

ON/RUN

Driving position.

All the electrical devices are available.

START

The engine will start.

NOTE: Refer to "Starting The Engine," in "Starting And Operating" for further information.

(Continued)

When opening the driver’s door and the ignition is in ON/RUN (engine not running) position, a chime will sound

to remind you to place the ignition in the OFF position.

3

In addition to the chime, the Vehicle On message will display in the cluster (if equipped).

NOTE: The power window switches and power sunroof (if equipped) will remain active for three minutes after the ignition is cycled to the OFF position. Opening either front door will cancel this feature. The time for this feature is programmable.

(Continued)